wanted to add this. Its a replacement auto shifter bezel. Just the black trim part, the rest of the parts are not designed, and it would be tough to print the curved lens...but if you have a shifter cover that has broken tabs, this will work to replace it. I'd recommend ABS or ASA material, PLA could melt in the interior of a car and there isn't any reason to go with any of the filled engineering fillaments. PETG may work also, but I've not done much with PETG. The tricky part (going on a few years since I actually made this) is removal of the parts you're keeping from the junk. IIRC, they are heat staked together. I included posts on the new design to use sheet metal screws to hold the assembly together.